APT Series, Triac, SCR Output Optoisolators

Triac and SCR output optoisolators are electronic devices that enable the bi-directional or unidirectional control of an AC (alternating current) source while ensuring electrical isolation between the control circuit and the load circuit. They are commonly used in applications where precise control of AC power is required, such as in dimming circuits, motor control, and power switching. These optoisolators consist of an LED (Light-Emitting Diode) optically coupled to a photodiode within a single device package. The LED emits light when current flows through it, and this light is detected by the photodiode. The photodiode then controls the gate of the Triac (Triode for Alternating Current) or SCR (Silicon Controlled Rectifier), which are semiconductor devices used for controlling AC power. In addition to providing electrical isolation, some optoisolators designed for AC power control may include zero-crossing circuitry. This circuitry ensures that the Triac or SCR is triggered at the point where the AC voltage waveform crosses zero. This helps minimize electrical noise and reduce stress on the components during switching operations. When selecting Triac and SCR output optoisolators, several parameters need to be considered. The on-state current rating specifies the maximum current that can flow through the Triac or SCR when it is in the conducting state. The forward voltage indicates the voltage drop across the LED when it is illuminated. The turn-on time refers to the time taken for the Triac or SCR to switch into the conducting state once the photodiode receives the control signal. Lastly, the mounting type specifies the physical configuration of the optoisolator package, such as through-hole or surface mount. In summary, Triac and SCR output optoisolators allow for the controlled switching of AC power while ensuring electrical isolation between the control and load circuits. They consist of an LED optically coupled to a photodiode, with the photodiode controlling the gate of the Triac or SCR. Some optoisolators may also include zero-crossing circuitry. When selecting these optoisolators, factors such as on-state current, forward voltage, turn-on time, and mounting type should be taken into consideration.